Making the Crown Before the Tooth Is Prepared
In August, my colleagues and I published a pilot feasibility study in Communications Medicine. We tested whether a robot can prepare a tooth for a crown accurately enough to change the order in which crowns are made.
Today a crown is a sequence: prepare the tooth, scan it, design the crown, mill it, then seat it. Each step waits on the one before it. If a robot can cut the tooth to a shape planned in advance, the crown can be designed and milled from that same plan before the patient arrives, and seated as soon as the preparation is done.
We tested this in six patients receiving single posterior crowns. A zirconia crown was made ahead of time from each patient’s digital plan. At the visit, the robot carried out the planned preparation while the dentist supervised with a foot-activated safety switch. Then the dentist seated the pre-made crown.
What we found
- The robot completed the planned preparation in all six patients, with no adverse events.
- No patient reported pain or discomfort during the procedure, right afterward, or at one week.
- On average, preparations deviated from the plan by 39 micrometers, about the width of a human hair. 98% of the prepared surface was within 100 micrometers of the plan.
- Five of the six pre-made crowns fit well enough to be permanently cemented at the same visit. The sixth was used as a temporary.
What it means
Six patients make a feasibility study, not proof. But the study shows the accuracy is there to separate making the crown from preparing the tooth. Larger trials are now under way to measure long-term clinical and economic outcomes.
The full paper is open access: Semi-automated robot for tooth restorative treatment: a pilot feasibility study.